Safer, more efficient, longer lasting…VariCap. The rebar cap that won’t fall off.
- It won’t fall off in horizontal or vertical applications.
- Goes on and comes off with ease.
- Zero maintenance.
- CAL/OSHA certified/Federal OSHA compliant
|| patented design ||
It’s patented design makes it safer.
The VariCap doesn’t deform when installed due to its patented design.
When a rebar cap becomes deformed it no longer fits properly and ends up falling onto the ground. Craft use duct tape and tire wire to try and get them to stay on which is inefficient and costly.
Well no more! VariCap’s stay on in vertical and horizontal applications every time you use them. Set it and forget it.
Compliance
- CAL/OSHA 1505
- CAL/OSHA 344.90
- CAL/OSHA 1712
- Federal OSHA 1926.701 (b)
|| cap on your labor cost ||
Put a “cap” on your labor cost.
As shown in the chart below, the VariCap’s last longer than traditional caps. At a minimum of 1000 uses on all size bars (as shown), if you used a VariCap once a week it will last you 20 years. Read more on the rebar cap case study.
With an average use rate of 1000 uses you have to replace other caps 10x’s before replacing a VariCap.
Why buy 10 when you can buy 1 VariCap!
|| Description of the VariCap ||
VariCap – Superior Design
for Today’s Rebar Protection.
- 5 times more efficient than traditional caps and 2×4 systems
- Made in the USA
- CAL/OSHA certified/Federal OSHA compliant
- Reusable – made to last again & again
- Doesn’t fall off
- Doesn’t deform
- Zero maintenance
- Set it and forget it
-
Product Overview
The VariCap is an impalement protection cap that was designed by a construction professional. This impalement protection safety device is intended to protect workers from lacerations and falls from height. Tested to CAL/OSHA standard 344.90.
The yellow end cap that stabilizes the cap on the bar or other hazard is replaceable if it ever becomes damaged for any reason. You simply take the damaged one off and push on a new one. The replacement caps can be purchased separately.
-
Uses
The Varicap is designed to be used at or above grade. It is designed to protect against impalement from a maximum fall height not to exceed 7 1/2’. It can be used on rebar #4-#11.
-
Quality Assurance
The VariCap is an impalement protection device. It is designed to be used multiple times on multiple job sites without deformation. The VariCap must be inspected before every use. If the orange base is damaged in any way, please discard immediately. The yellow end cap that stabilizes the cap on the bar or other hazard is replaceable if it ever becomes damaged for any reason. You simply remove the yellow end cap from the orange base and push a new one on. The replacement caps can be purchased separately.
-
Sustainability
The construction industry has a responsibility to build for the greater good. In our journey to green planet construction we can help lower your total embodied carbon footprint by diverting the total number of rebar caps from landfills. Because the VariCap is reusable many times over our products life cycle is much longer than traditional caps and our replaceable end caps are recyclable. Even the little things can make a difference.
We know
what it’s like…
To have rebar caps fall off leaving people exposed to impalement hazards. How often have you tried to re-install a cap that has fallen off and can’t because it’s destroyed? You don’t carry the necessary tools to bandaid it back on.
That’s why we’ve spent years of research and development to design the perfect rebar cap that won’t deform and fall off. If you can relate to the frustration of constant maintenance, then we can help you create a lean, efficient, safer job site by using the VariCap.
Our Videos
